the rocky and i am me show

liam wont mind

noo it'l be fine tehe....

well if u do get this car and get the engine from it u could be doing the head work whilst the engine is being put it then it would make better time for getting it all together and runing

yeah but its the cost of it all that i will struggle with

yers this is the problem but u could make some money selling a few bits cus u've still got the other more door ant ya

yeah but i need the engine putting in quickly

hmmmm yerz this is tru . if u needed a few bits gettin to get it in i dnt mind lendin some pennies if it helps u get bak on the road

i would have everything i needed if i got the full car.
it can survive for a while before it needs rebuilding so im not in a rush to change the head gasket and stuff

well thats not 3 bad then s'pose cuz if it'l get u about 4 a bit untill u've saved up some pennies then it'l be aryt and give u more time to sort out any little niggles u myt get

yeah it should get me on the road again with a bit more power aswell

yer this is tru...

what power figures are they chucking out ????

115bhp standard i dont know about torque but its still 40bhp more than a driver

not 3 bad then and being in ur lightweight driver aswell should be good for some happy miles

yeah it should be fairly rapid

should be.. will be a vast improvement over ya 1.6

yeah i just need some spacers for the front so the brakes will clear my wheels.
also will have rear discs and i belive it has anti roll bars aswell so im improving alot

r u guna just put the rear axle on urz then with the roll bar and disks all attached then and swapping over front brakes

yeah,
will also have a decent set of driveshafts

thats always a bonus then init. u'll be getting allot out of it then when its all put together sounds like a good investment

its also got a full hard scuttle,bigbumper arches and side skirts and a stainless exhaust

rlli is starting to sound definately worth it r u getting it or are u thinking about it ??

im fairly sure im getting it.

good stuff m8 will be well worth the work

yeah but i dont know if i will be cleaning the bay before the engine goes in.

all depends on time dunt it tho the bay cn be cleaned up when u get the head gaket nd belt done

yeah but its alot easier to clean the bay without the engine in