retarded clutch question...

This is a stupid question, but I'm feeling groggy and can't work it out for mysel!

My clutch bites really high, and it was slipping due to my greasy hands on the friction plate. Now this had worn off and although its high, it was biting ok. Now its started slipping again. When I had the clutch off it seemed to have a decent amount of meat on it. Anyways my question is to get the biting point lower on the pedal do I tighten the cable or loosen it?

Loosen it.
Although it would only take you minute to try it both ways and see which way your pedal goes you lazy sod

Rims lookin good btw

cheers dude. Them cables are normally a bitch to adjust due to rust on the threads, wanted to be able to sort it in one go And its always much easier to stick a bottle jack under the clutch arm to slacken the cable. Top tip for you kids!

Yeah i tend to use me porta power

We're both retards, I had to tighten it stop it slipping. The pedal feels a bit odd now but its biting half way and not slipping. Just hope its not so tight that it snaps!

Dont be so bloody stupid

You tighten the clutch up,you are engaging it more

If it works better than before then I'm happy. Might let it off a tad more though just to be safe. I don't mind it biting high its just the slipping I can't tolerate

Dont put oil on the clutch plates then you numpty
Think yourself lucky,at least you didnt pour oil on your clutch like matey did

I still have a big hole in my gearbox where a green bung should go........could i get it off you at the meet dude?

yes, yes you can

Im now Excited.com

I can pop it round later if you want mate? I might forget otherwise

get a room you two